• Login
    View Item 
    •   Home
    • UNDERGRADUATE THESES (Koleksi Skripsi Sarjana)
    • UT-Faculty of Engineering
    • View Item
    •   Home
    • UNDERGRADUATE THESES (Koleksi Skripsi Sarjana)
    • UT-Faculty of Engineering
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    RANCANG BANGUN PORTABLE SOLAR CHARGER BERBASIS ARDUINO UNO

    Thumbnail
    View/Open
    Arobin Jaka Mahendra - 111910201036.pdf (1.953Mb)
    Date
    2016-11-28
    Author
    Jaka Mahendra, Arobin
    Metadata
    Show full item record
    Abstract
    Design Of Portable Solar Charger Based Arduino UNO; Arobin Jaka Mahendra; 1119102036; 2016: 54 pages; The Study of Engineering Bachelor Programme (S1), Department Of Electrical Engineering, the Faculty of Engineering, Jember University. The development of modern electronic tool like gadgets that support telecommunications has changed the lifestyle of the community for the better. However, there are limitations to the energy in the device which makes an important problem to the users. The solar panel is one of the appropriate energy to overcome the problem. In this system there is 20 wp solar panels used to charge the battery by converting sun’s rays into electricity and there are control devices Arduino UNO which is used to generate a pulse wave that triggered the IRFP460 MOSFET in DCDC converters that is used in the system. The resulting voltage by the solar panels amount of +19.3 V derived using buck converter becomes +13.9 V with a maximum charging current of 0.97 A to charge the battery back-up 12 V for +4 hours. Then the back-up battery voltage 12 V was lowered again with buck converter to 4.96 V with a current of 0.5 A for charging mobile phones. On the other hand there is a boost converter is used to raise the voltage of the battery back-up becomes 19.96 V with a current of 2 A for charging laptop battery. On the change of load, duty cycle value that is used according to the determination of the desired voltage load, to reduce ripple in the output converter used a series L and C as an LC filter so that the output waveform obtained better.
    URI
    http://repository.unej.ac.id/handle/123456789/78235
    Collections
    • UT-Faculty of Engineering [4203]

    UPA-TIK Copyright © 2024  Library University of Jember
    Contact Us | Send Feedback

    Indonesia DSpace Group :

    University of Jember Repository
    IPB University Scientific Repository
    UIN Syarif Hidayatullah Institutional Repository
     

     

    Browse

    All of RepositoryCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Context

    Edit this item

    UPA-TIK Copyright © 2024  Library University of Jember
    Contact Us | Send Feedback

    Indonesia DSpace Group :

    University of Jember Repository
    IPB University Scientific Repository
    UIN Syarif Hidayatullah Institutional Repository